DHT22 Digital Temperature And Humidity Sensor
SKU: 657- Description
- Reviews (0)
Description
Product Description
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed).
Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin.
Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive.
Comes with a 4.7K – 10K resistor, which you will want to use as a pullup from the data pin to
Be the first to review “DHT22 Digital Temperature And Humidity Sensor”
Most Viewed Products
-
You've just added this product to the cart:
3.5 inch TFT LCD Touch Screen Module For Arduino UNO R3, Mega2560 Board
3.5 inch TFT LCD Touch Screen Module For Arduino UNO R3, Mega2560 Board
-
You've just added this product to the cart:
AC PWM 4000W 220V AC SCR Voltage Regulator Dimmer Electric Motor Speed Temperature Controller+Digital Meters For Water Heater Motor
AC PWM 4000W 220V AC SCR Voltage Regulator Dimmer Electric Motor Speed Temperature Controller+Digital Meters For Water Heater Motor
-
You've just added this product to the cart:
RS232 to TTL Converter Module MAX232 Module
RS232 to TTL Converter Module MAX232 Module
-
You've just added this product to the cart:
18650 Lithium Cell Battery Holder Bracket for DIY Battery Pack
18650 Lithium Cell Battery Holder Bracket for DIY Battery Pack
Reviews
There are no reviews yet.