Type-C USB 5V 2A Boost Converter Step-Up Power Module Lithium Battery Charging Protection Board
SKU: 1829- Description
- Reviews (0)
Description
Specification:
Input voltage range: 5 ~ 5.5V
Charging cut-off voltage: (4.2v/4.35v) ± 0.5%
Charging current: 2.4a ± 5%
Boost output voltage: 5V ~ 5.15v (line loss compensation)
Boost output voltage ripple: 100mV
Boost output current: 2A
Boost conversion efficiency: 92.5% (3.6V input, 5v2a output)
Static current at battery end: < 30uA
Function introduction
When the load current is less than 50mA continuously, the output will be turned off.
It supports the external key, which is connected to the K point and the output negative pole. Short press to turn on the power display and turn on the 5V output. Two consecutive short presses will turn off the power display and turn off the 5V output.
When the charging current drops to 100mA after reaching the final floating charging voltage, the charging cycle will be automatically terminated.
When the battery voltage drops below 4.1V, the charging cycle starts again.
When the battery voltage is lower than 2.8V, the battery will be pre charged with a current of 180mA.
The usb-a base welding position is provided on the back of the product, which can be installed manually.
Be the first to review “Type-C USB 5V 2A Boost Converter Step-Up Power Module Lithium Battery Charging Protection Board”
Most Viewed Products
-
You've just added this product to the cart:
R305 Integrated Optical Fingerprint Module Fingerprint Sensor Fingerprint Reader
R305 Integrated Optical Fingerprint Module Fingerprint Sensor Fingerprint Reader
₨3,800.00 -
Arduino Nano V3
-
You've just added this product to the cart:
LCD Display Module 1602 16x02 IIC/I2C LCD-1602 - For Arduino - 5V Green/Yellow
LCD Display Module 1602 16×02 IIC/I2C LCD-1602 – For Arduino – 5V Green/Yellow
-
You've just added this product to the cart:
3D Printer 20x04 LCD Controller With SD Card Slot
3D Printer 20×04 LCD Controller With SD Card Slot
Reviews
There are no reviews yet.