DHT22 Digital Temperature And Humidity Sensor
SKU: 657- Description
Description
Product Description
The DHT22 is a basic, low-cost digital temperature and humidity sensor. It uses a capacitive humidity sensor and a thermistor to measure the surrounding air, and spits out a digital signal on the data pin (no analog input pins needed).
Simply connect the first pin on the left to 3-5V power, the second pin to your data input pin and the right most pin to ground. Although it uses a single-wire to send data it is not Dallas One Wire compatible! If you want multiple sensors, each one must have its own data pin.
Compared to the DHT11, this sensor is more precise, more accurate and works in a bigger range of temperature/humidity, but its larger and more expensive.
Comes with a 4.7K – 10K resistor, which you will want to use as a pullup from the data pin to
Most Viewed Products
-
You've just added this product to the cart:
PCA9685 16 Channel 12-bit PWM Servo Drive Shield Board DC Motor Driver Module I2C Controlled PWM Driver for Arduino
PCA9685 16 Channel 12-bit PWM Servo Drive Shield Board DC Motor Driver Module I2C Controlled PWM Driver for Arduino
-
You've just added this product to the cart:
3D Printer 20x04 LCD Controller With SD Card Slot
3D Printer 20×04 LCD Controller With SD Card Slot
-
You've just added this product to the cart:
Atmega32u4 Esplora Joystick Game Program Module crystal oscillator Temperature Light Sensor Board
Atmega32u4 Esplora Joystick Game Program Module crystal oscillator Temperature Light Sensor Board
₨2,500.00 -
You've just added this product to the cart:
DC 12V 0.3A 4N Pull Push Type Frame Solenoid Electromagnet Linear Motion 6.5mm Stroke JF-0520B
DC 12V 0.3A 4N Pull Push Type Frame Solenoid Electromagnet Linear Motion 6.5mm Stroke JF-0520B
